Make four small circular cuts along the dotted lines as shown in the picture. Also cut out the two tyres.

1. Cut the paper switch along the dotted lines
2. Fold along the centre
3. Gently press the top most part

Ensure that the buzzer and the LED light passes through the hole. Paste the two tyres over the DC motors as shown in the picture. Press 108 call button and all the components are turned “ON”.

Cut along the dotted line to make a small circular hole. Also cut out the drum image as shown in the picture.

1. Cut the paper switch along the dotted lines
2. Fold along the centre
3. Gently press the top most part

Fold the design sheet over the circuit sheet, ensure that the drum is stuck over the DC motor. Press the start button and the drum starts to spin.

Cut along the dotted line where the flame/burner symbol is located as shown in the picture. Stick a tracing paper behind the cut out portion.

1. Cut the paper switch along the dotted lines
2. Fold along the centre
3. Gently press the top most part

After folding the design sheet over the circuit sheet, press on the cloud image. The LED light turns “ON” as shown in the picture.

Make a circular cut along the dotted line as shown in the picture. Also make a cut out of the rocket.

1. Cut the paper switch along the dotted lines
2. Fold along the centre
3. Gently press the top most part

Paste the transparent strip over the DC motor. Next, paste the rocket on one end of the transparent strip. Press the “start” button and the rocket starts to revolve.

Make a circular cut along the dotted line on the design sheet. Also cut out the drill and the key as shown in the picture.

Positive side of the coin cell battery is facing down and the negative side is facing up.

Fix the drill on top of the vibration motor and attach a magnet behind the key. Bring the key near the “START” button and the vibration motor turns “ON”.

Cut along the dotted lines for the flame and water symbols. Also make a cut out of the valve and matchstick symbol as shown in the picture. Place the tracing sheet on the back of the cut out hole.

Positive side of the coin cell battery is facing down and the negative side is facing up.

Attach magnet behind the matchstick and the valve and bring them near the matchstick and valve starting point as shown in the picture. When the matchstick is brought near the matchstick image, red LED light turns “ON”. When the valve is brought near the valve starting point, blue LED light turns “ON”.